Velleman 1.75mm Spool Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A spool clip for 1.75mm Velleman filament spools. It is 10mm thick by default, but you can scale the Z dimension to…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 25
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
A spool clip for 1.75mm Velleman filament spools. It is 10mm thick by default, but you can scale the Z dimension to change this
Instructions
Print these at 0.2mm layer height. Use a low infill, if any, as this will keep them flexible enough to snap over the lip of the spool. Because these are so small, you can print several at once without increasing the overall print time by much. I printed four of these in about fifteen minutes, whereas one would take about ten minutes to print.
Category: 3D Printer Accessories