Centauri Carbon Quick Release Panel Spacer

This spacer is separated into two main sets - one set of parts for the chassis, and one for the panel. The parts interlock at joints for a secure fit when fastened in their respective locations. Once both sets are installed, the spacer allows a short upward sliding motion to release the panel. This is useful for those using our internal spool holder or those wishing quick access for maintenance or photography.

You will need 8x 8 mm M3 machine screws, 8x 4 or 5.5mm M3 machine screws, and 8x 4mm M3 heatset knurled nuts. The nuts go into the panel side of the spacer. Leave the panel side loose before fitting the panel the first time, then tighten. The sliding action may be somewhat tight at first. Repeatedly opening and closing will help, and you may also wish to add some graphite or moly dry lube to the contact points.

This model is designed to use knurled heat-set inserts. If you have never done heat-set inserts before, you will need the following to get started:

• Soldering Iron - I use the Yihua 939D+
• Heat-set Insert Tool/Tips - This set is compatible with the 939D+
• Threaded Inserts, like this Brass Threaded Inserts Assortment Kit

If you don't want a more expensive DC soldering iron similar to the Yihua mentioned above, and want an all-inclusive and inexpensive way to get started, this kit will work just fine.

There are heat-set presses to help guide threaded inserts into your print. They typically include tips and the soldering iron, like the ones mentioned above. These are nice to have, but not a requirement if you have a steady hand.

Help financially support further development of these models at no extra cost by using the links in this description to purchase any needed hardware or tools. Thank you!

Interested in the internal spool concept? Check it out:

Centauri Carbon Internal 1kg Spool Mount Kit by Synthetic Electron 3D