Enclosure for MKS Robin Nano V3.1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Electronics enclosure for two boards (MKS Robin Nano V3.1 and Raspberry Pi 4) and screen (MKS TS35 V2)
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 55
- Makes
- 0
- Views
- 343
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is an electronics enclosure for a custom 3d printer I am building. It houses two different control boards. In my case it will be a MKS Robin Nano Ver3.1 and Raspberry Pi 4.
The boards sit on a panel which can be slided in and out; and and each panel is fixed with two M3 bolts to the mainframe. This provides more flexibility during assembly especially for cable bundles.
There will be a second iteration for the following improvements
- Change M5 bolts to M3 for panels; and use countersunk instead of buttonhead (aesthetics)
- Use spring-lock mechanism to fix the boards in place instead of M3 bolts
For durability reasons I used heat inserts to fix the screen, the electronics boards, rubber feet and the fan. You are welcome to change it to nuts & bolts. In addition the M5 nuts on each panel shall be a tight-fit. Please make sure to check the holes for your M5 nuts.
All parts are printed with PLA+ and without any supports. The final model will be printed with PETG. Other than the printed parts you will need below items for assembly
| Component | Quantity (eaches) | Comments |
| M5 nut | 32 | to assembly the panels, can be changed to M3 |
| M5x10 buttonhead | 24 | to assembly the panels, can be changed to M3 |
| M3xH3 heat set insert | 8 | to assembly the boards to panels and panels to frame; can be changed to nuts & bolts |
| M3 nut | 6 | to assembly the screen to frame |
| M3x12 buttonhead | 6 | to assembly the screen to frame |
| M3xH6 heat set insert | 6 | to assembly the screen to frame; can be changed to nuts & bolts |
| M5x20 buttonhead | 4 | to fix the rubber feet to bottom panel |
| M3x5 flanged nut | 4 | to fix Robin Nano to board panel |
| M5xH8 heat set insert | 8 | to fix the rubber feet to bottom panel and fan to back panel; can be changed to nuts & bolts |
| M5x35 allen | 4 | to fix the fan to back panel |
| M3 male to female standoff (PCB spacer) | 4 | to fix Robin Nano to board panel |
| M5 rubber foot | 4 | |
| M3x6 buttonhead | 4 | to fix the board panels to main frame |
| 92x92x25 fan | 1 |