Zero Toolhead Upgrade for Sovol SV06 / SV06Plus / SV06Ace (Beta)

🚀 Bring Your Sovol SV06 Series to 2025 Standards!
This is a work-in-progress upgrade using the Zero Toolhead – the same one used on the Sovol Zero and SV08 MAX – adapted to fit the SV06, SV06+, and SV06 Ace.
It’s lighter, cleaner, and built for modern performance!

🔧 Status: Beta – Still Under Testing

This model is being published early due to strong demand from the community. It's not final, but it's very close — and we’re opening it up to help more testers join and give feedback. Final tweaks will follow as we confirm fitment and firmware.

✅ What's Included:
 

• Mount for SV06 Ace
• Mounts for SV06 / SV06+

Pre-aligned  STL files for beta testers

Notes for firmware setup (final config coming soon)

🧰 What You Need for the Upgrade

🔹 Required Hardware:

🔸 For SV06 Ace: 

Just plug and play with:

The Zero Toolhead   https://www.sovol3d.com/products/sovol-zero-extruder-kit?sca_ref=9255056.0Rfl6jWc9KQN&sca_source=printables 

The UTC/U2C CAN adapter 👉 https://tidd.ly/44ix5xh

Screws 
4x M3 x 8
6 x M3 x 10
2 x M5 x 20 
1 x M5 x 30

Washers
1 x M5 x 10 x 1

Nuts
2 x M2.5 

Heat set inserts
2 x M3 x 4.5 OD x 4.5 mm long 
6 x M3 x 4.5 OD x 5.7 mm long
2 x M5 x 6mm long  

🔸 For  SV06 and  SV06 Plus

👉 Zero Toolhead – Buy it here (affiliate link):
 https://www.sovol3d.com/products/sovol-zero-extruder-kit?sca_ref=9255056.0Rfl6jWc9KQN&sca_source=printables  
(Costs you nothing extra – helps support development)

🔸 For SV06 / SV06+:

You’ll need to convert to Klipper firmware. Recommended options:

BTT Manta M4P + CB1 (MCU + Pi in one)
👉 https://tidd.ly/4lqrg7N

Or use an SKR Pico + Raspberry Pi

Or your existing board + Pi if you already run Klipper

You'll also need a U2C/UTC CAN adapter:
👉 https://tidd.ly/44ix5xh

Screws 
6 x M3 x 8
4 x M3 x 12
4 x M3 x 16

Heat set inserts
7 x M3 x 4.5 OD x 4mm 
4 x M3 x 4.5 OD x 5.7mm 

Nuts
2x M2.5 
 

🙌 Special Thanks

Huge thanks to Banana Joe who bought and sent us the Zero Toolhead so we could develop this upgrade for the community!

💬 Want to Help Improve It?

If you test it, please leave a Make or comment with your results and suggestions. We’ll include all confirmed improvements in the final release.

Let’s bring our Sovol printers to the next level – together! ⚙🔥


❤ Support Our Work If you enjoy our content and want to help us keep creating: 
🔹 Become a supporter on Printables: https://www.printables.com/@Nadir#[email protected]