Stiltz Elevator Remote Floor Jack Holder
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€4.21 – €5.15 net (excluding VAT)
For file: Stiltz Holder_0.2mm_PETG_MK3S_5h10m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.68 excluding VAT (range midpoint).
- Weight reported by the author
- 52 g
- Print time reported by the author
- 5.16 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Holds a Stiltz elevator remote control on a floor jack using the wire from the original wall mount.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This design holds a Stiltz elevator remote using the wire from an original wall mount that comes with the remote. It slips around a floor jack (2.25" diameter top pole, 2.5" diameter bottom pole) without any additional attachments required. It rests on the lower, larger diameter pole and does not pull off. Holes are included in the model if it is desired to permanently secure it to the floor jack with zip ties.
This was printed with PETG and minimal supports were used from the build plate just for the rounded part near the build plate. The FreeCAD 1.1 model is included and is parametric.