Super Nintendo (SNES) USB Daemonbite Enclosure For MiSTer FPGA
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Daemonbite enclosure to be used for USB-C Arduino Pro Micro board (ATmega32U4) and SNES controller port for MiSTer FPGA.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 44
- Makes
- 0
- Views
- 320
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The goal was to design a minimalistic enclosure that would allow for inclusion of an arduino pro micro board (ATmega32U4) and OEM Super Nintendo / Super Famicom (SNES) style controller port. The design is based on a USB-C version of the arduino board. The arduino board has a snug fit - please be sure your arduino board will fit properly. It's possible some arduino boards may use slightly different sizing.
Printing Suggestions:
Material - PLA
Enclosure base - I recommend printing this component with the flat surface on the print bed. Layer height .14mm first layer and .20mm remaining layers. I used 15% infill. I only used supports for the 4 screw hole countersinks. I did not use supports for the USB-C port cutout, however depending on your printer, you may want to enable supports for that as well.
Enclosure top - I recommend printing this component with the flat surface on the print bed. Layer height .14mm first layer and .20mm remaining layers. I used 15% infill. I did not need supports for the angled edges.
Adapter Parts Used:
- (1) Arduino Pro Micro board (ATmega32U4) with USB-C connector (board dimensions: 35mm L x 18.4mm W x 1.65mm H)
- (1) Female SNES controller port
- (4) 12mm M3 hex screws
- (1) 5mm M1.4 screw
- (4) 5mm M3 brass screw inserts
- 22 gauge silicon wire
- 1/8" ~ 3/16" shrink tubing
Adapter Assembly Instructions:
I have also created a YouTube tutorial video featuring assembly of the adapter and setup from start to finish.