Yes/Fairy bottle upside-down stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A collar to pop on below the cap of a dish detergent bottle, so that the last, most determined bit of fluid can be used.
- Rating
- 5 / 5
- Likes
- 62
- Downloads
- 120
- Makes
- 5
- Views
- 1,670
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Bottle stand
It's useful to be able to rest the detergent bottle upside down to get out the last bit of dishwashing fluid, most stubbornly refusing to clean your dishes.
Granted there are numerous ways to get this done, but this is my contribution. A “silly cone” for the bottle, like it's been to the vet. It clips around the bottle neck and stays there so it doesn't get lost (until the bottle does). It also allows for the operation of the cap.
Printing
Print with the narrow end down and it did fine without any supports. I tried to avoid Brim, since it is annoying to remove all the way around, so I made that end pretty large and flat.
Printed in generic black PETG
Next Steps
I'd like it to just be tall enough, so you can easily see if the cap is not fully closed, but couldn't be bothered to print many iterations, so supplied the f3d if anyone is interested.
It's not very fancy looking, maybe add some speed holes or some such.
some way to hang it up so it doesn't get lost while the bottle is almost full.