UFO Abduction Lamp with blinking lights
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
you need: glas cylinder with both ends open about 80mm in width 27x blue LEDs 3x white LEDs 30x 200 ohm resistors 4x…
- Rating
- 5 / 5
- Likes
- 180
- Downloads
- 518
- Makes
- 1
- Views
- 4,429
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial
you need:
glas cylinder with both ends open about 80mm in width
27x blue LEDs
3x white LEDs
30x 200 ohm resistors
4x 2k ohm resistors
4x 2N2222 transistor
ARDUINO nano
5M ohm potentiometer
7V power supply
green fabric
Use transparent filament on the file LED_cap_trans.stl.
Print instructions
Arduino Code
int A = 12;
int B = 10;
int C = 8;
int D = 6;
const int poti = 0;
void setup()
{
pinMode(A, OUTPUT);
pinMode(B, OUTPUT);
pinMode(C, OUTPUT);
pinMode(D, OUTPUT);
}
void loop()
{
int tDelay = 575;
int analogIn;
analogIn = analogRead(poti);
Serial.println(analogIn);
// all on
if(analogIn < 200){
tDelay = 50;
delay(tDelay);
digitalWrite(A, HIGH);
digitalWrite(B, HIGH);
digitalWrite(C, HIGH);
digitalWrite(D, HIGH);
} else if (analogIn < 800){
// * rotate **
tDelay = analogIn - 150;
digitalWrite(A, HIGH);
delay(tDelay);
digitalWrite(A, LOW);
digitalWrite(B, HIGH);
delay(tDelay);
digitalWrite(B, LOW);
digitalWrite(C, HIGH);
delay(tDelay);
digitalWrite(C, LOW);
digitalWrite(D, HIGH);
delay(tDelay);
digitalWrite(D, LOW);
} else {
// ** blink
tDelay = analogIn - 400;
digitalWrite(A, HIGH);
digitalWrite(B, LOW);
digitalWrite(C, HIGH);
digitalWrite(D, LOW);
delay(tDelay);
digitalWrite(A, LOW);
digitalWrite(B, HIGH);
digitalWrite(C, LOW);
digitalWrite(D, HIGH);
delay(tDelay);
}
}