5 Razor stand - Works for Double Edge Safety Razors and Cartridge Razors
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stand to accommodate most wet shaving razors.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 106
- Makes
- 1
- Views
- 438
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
N.B. Razors shown for demonstration Only
I've grown a modest collection of razors and wanted a way to show/display the ones that I'm not actively using. Most commercially available options held to few razors, were too costly, or both. Despite it being too small I liked the Parker stand, so I took inspiration from that.
I printed it in PLA, so not the most heat resistant, but I've no doubt it would print well in other materials too. I found it prints fine on its side with no support, or upright with minimal organic supports. It's worth experimenting.
Dimensions (Approx.) as follows:
- Width: 160mm x Height: 66mm x Depth: 44mm
- Hole Diameter: 15.5 mm
I hope this helps. Please leave a like if it does, and post any makes or remixes.
All designs (however rubbish) are my own, unless they're an accredited remix of another great design. They are made available for non-commercial use. Sale of design or prints is prohibited. You may find some of my other models interesting and/or useful too, please take a look.