1 / 5
Model Ship Waterline Marker
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this to add a waterline mark on my ship models.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 190
- Makes
- 0
- Views
- 600
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
I designed this to add a waterline mark on my ship models. It was printed in PLA with no supports and takes approximately 2.5 hours. The hole for the pencil is 7.54 mm (19/64") and is a press fit if an 6 sided pencil is used. A set screw may be needed if using a round pencil.. The hole for the tightening screw for the vertical height is 5.16 mm (13.64") and I used an M10x20 bolt with a nut and washer. I hope you enjoy the print.