Everyday Individual Screwdriver Holders
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Various Individual Screwdriver Holders
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 34
- Makes
- 1
- Views
- 356
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Although I have since found similar on prusaprints my remix came from https://www.thingiverse.com/thing:2918462/files.
Again looking for individual holders for my various and individually purchased screwdrivers to mount in a small area. The ones I fell upon were for a set or sets of Wera screwdrivers, BUT hole sizing a little small for my day to day screwdrivers.
I have initially made some blanks for anyone to do there own thing using a small shaft hole so that you can easily increase as needed.
The originals appeared to be mounted on a piece of ply away from the wall making it easier to remove said screwdriver. As this was not going to be available to me I made the bases 4mm thicker and reduced the original angle from what appears to be 10º to 7.5º, so as to accommodate slightly longer screwdrivers. I also have increased the mounting screw holes to 4mm. I have included where possible my fusion 360 file also.
I had no need for the numbering system and just went for S,M,L A multi colour filament printer would have been better than my maker pens.
Remember to set the base flat to print plate before gcoding.
Pozi Drive
- S = 4.5mm Diameter
- M = 6.5mm Diameter
- L = 8.5mm Diameter
Slotted
- S = 5.5mm Diameter
- M = 9.5mm Diameter
- L = 13mm Diameter
Electrical
- 7.5mm Diameter