1 / 5
Babymoov Nutri-baby blender base drive gear replacement — image 1
1 / 5

Babymoov Nutri-baby blender base drive gear replacement

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement drive gear for the Babymoov Nutri-baby's blender base unit

Rating
0 / 5
Likes
0
Downloads
42
Makes
0
Views
133
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
GNU General Public License v3.0

My wife unfortunately blitzed some large chunks of frozen pineapple, which stripped the hex drive on the babymoov unit. 
 

It’s actually quite easy to replace.

detach the unit from the babymoov 

squeeze together the two silver legs with the rubber insert and it should start to pop out. There’s only four clips that hold it on. Undo the now obvious screws, and you should be able to open it up and remove the broken gear by just pulling it off. 
 

Recommend 3+ walls. I printed 0.12mm layers but I think you could easily do 0.2mm. 
 

nothing special, I printed two units one flat and one at 45 degrees. Tried the flat unit and it’s not broken yet, despite concern over shear/layer lines on the hex drive.  

Tags