1 / 5
Babymoov Nutri-baby blender base drive gear replacement — zdjęcie 1
1 / 5

Babymoov Nutri-baby blender base drive gear replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement drive gear for the Babymoov Nutri-baby's blender base unit

Ocena
0 / 5
Polubienia
0
Pobrania
41
Wydruki
0
Wyświetlenia
131
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
GNU General Public License v3.0

My wife unfortunately blitzed some large chunks of frozen pineapple, which stripped the hex drive on the babymoov unit. 
 

It’s actually quite easy to replace.

detach the unit from the babymoov 

squeeze together the two silver legs with the rubber insert and it should start to pop out. There’s only four clips that hold it on. Undo the now obvious screws, and you should be able to open it up and remove the broken gear by just pulling it off. 
 

Recommend 3+ walls. I printed 0.12mm layers but I think you could easily do 0.2mm. 
 

nothing special, I printed two units one flat and one at 45 degrees. Tried the flat unit and it’s not broken yet, despite concern over shear/layer lines on the hex drive.  

Tagi