1 / 3
XIAO ESP32 SMA antenna case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
XIAO ESP32 case with a screw on SMA antenna
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 180
- Makes
- 3
- Views
- 839
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
I needed a case to use my XIAO ESP32 as a ESPHome Bluetooth proxy. You will need a
2"/5cm UFL to SMA cable and an antenna.
Make sure that supports are completely removed around the seals - some bits tend
to stick which will prevent the case from snapping together.
Printing
- Print standing upright on the antenna port
- Supports enabled
- 0.16mm layer height
- 5 walls
- Outer-inner wall order
Assembly
- Place the PCB bottom side down into the half with the tabs on top
- Place the SMA connector nut into the nut trap
- Insert the tabs into the holes on the top part of the case and snap it together at the antenna port
- Tighten the nut