Yarn cone winder v2 - motorized ver.for JGA25-370
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is the YARN WINDER v2 MOTORIZED version adapted for the JGA25-370 motor.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 241
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the YARN WINDER v2 MOTORIZED version adapted for the JGA25-370 motor.
In the remix, I added:
- GEAR_24 version for the JGA25-370 motor
- YARN_Housing_bottom version for the JGA25-370 motor
- YARN_Housing_bottom version for the JGA25-370 motor with six M3x5x4.2mm heat inserts
Parts needed:
- M6 rod 147 mm (grooved drum fork shaft)
- M6 rod 66 mm (winding shaft)
- M6 rod 20mm (connection between upper and lower grooved drum cap, loose fit)
- M6 nyloc hex nuts (manual 4x, motorized 3x)
- M6 normal hex nuts (manual 2x, motorized 1x)
- lock big gear in place (only in manual version)
- top of fork shaft (so you can hand-adjust how tight or loose the drum fork can move) - M3 screws 6mm (manual 4x, motorized 11x)
- M3 screws 20mm (2x, fork arm)
- M3 screw 35mm (1x, yarn tensioner)
- M3 hex nuts (2x, fork arm inside housing)
- Skateboard bearing 608-2RS (3x)
- short rubber band (for grooved drum)
- long rubber band (as drum fork spring, not too strong!)
- six M3x5x4.2mm heat inserts (OPTION)
Link to the kit(affiliate link):
JGA25-370 motor along with 12V DC speed controller.
CONCLUSION 💚💚💚If you enjoyed the project please like it.💚💚💚 Post your makes and let me know how it works out for you. If anyone has any comments about them - I'd be happy to listen and improve the models. ☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕ Did my project bring you joy, save you time, or solve your problem? Share your experience with me and brighten my day—buy me a Ko-fi! ☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕ |