Argon Poly+5 Case Lid (Rasperry Pi 5)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
replaces the lit of said Case for better airflow/thermals
- Rating
- 4 / 5
- Likes
- 3
- Downloads
- 43
- Makes
- 1
- Views
- 469
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
In stock form the Argon Poly+ for the Pi5 comes with a very restrictive Lid. Its allowing air in but no air out. If the stock pi5 cooler is used the cooler is basically cycling its own air. To fix that i created this mod. For those who use full size Hats on their Pi i made a second version that leaves as much room as possible inside and adds a side vent on the left so the fan would still be able to sniff some fresh air while doing fan things
update: added the on/off button in a printable form so it can be color matched to the lit.
testing results
Ive tested both variants now. Im running mainly home assistant and with the noFan variant(using the pi5 cooler with fan) it stays consistently around 47c vs the 55c on the fully closed stock Lid. with the Fan shroud version of the lid the temps can be reduced further down to ~45c.
recommendations
- print standing on the backside.
- no supports required for both versions
- optimised for 0.4 nozzle
- normal variant compatibility
- Pineboards Hatdrive Nano
- stock Pi5 fan cooler
- waveshare Active Cooler for Raspberry Pi 5 (the one with the smallest heatsink, single fan)
- no Fan variant compatibility
- all(as far as i know) full size Hats
- most cooling solutions
- On/Off button has support built in - just snip it of after printing
version log
v03 - on/off button added
v02d (initial release)