1 / 2
10 Inch Rack Mount for Lenovo Thinkcentre m920q (m720q) Tiny — image 1
1 / 2

10 Inch Rack Mount for Lenovo Thinkcentre m920q (m720q) Tiny

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remixed a 10inch rack mount for the Lenovo m920q/m720q Tiny

Rating
5 / 5
Likes
116
Downloads
1,153
Makes
5
Views
5,210
Reviews
5

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

I really liked Smelliot's version of the 10inch rack mount for Lenovo Tiny PCs, but the m900q's rubber feet are in a different position, so I remixed it and moved the feet channels to fit the m920q/m720q, and perhaps any other tiny's that match their footprint.

Main benefits of the design are a much much faster print, by removing all the unnecessary hexing, and actual screw holes that hold the Tiny in from the back side rather than relying purely on a friction fit.

Updated to v2: added a little more clearance on the wifi antenna side

From original post:

Print Instructions:  

  • 3 Perimeters minimum at 0.4mm nozzle
  • 0.25mm Layer heights
  • Print with the faceplate down (as loaded)
  • Preferrably PETG
  • At these instructions one mount weights around 130g of filament used.

Post Processing:

  • The model has some sacrificial bridging at the top to allow for the screw hole access and port clearance. Just clip the large part off with flush cutters, and nip the hole bridging so screws can pass through.

Optional Hardware:

  • Two M3x6 screws to secure the pc to the mount. You can get away with just one or none at all since the rubber feet make contact with the mount and gives good friction.

Tags

Tags