Reparaturkeil für Rolltür im Wohnmobil / Repair wedge for roller door in the camper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Einfache Reparatur mit Keil an Rolltürschiene / Easy repair with wedge on roller door rail
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 157
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
deutsch:
Ein kleiner Keil statt eine große Reparatur.
Unser Wohnmobil hat eine Rolltür zum Bad. Die hat auch jahrelang gut funktioniert. Irgendwann sind die Halterungen aus der Schiene an der Decke gefallen und die Tür war fast nicht mehr zu bewegen. Nachdem ich die Halterungen wieder eingefädelt hatte funktionierte es kurze Zeit wieder, dann ging die Sache von vorne los. Ich habe mir die Schiene genau angesehen. Im Eck ist sie besonders stark gebogen und dort hatte sie sich ein wenig geweitet. Dadurch sind die Einhängehalterungen der Tür an dieser Stelle heraus gerutscht. Zunächst dachte ich, dass die Schiene ersetzt werden muss und dass das eine blöde Reparatur wird. Bis mir dann die Idee kam, die Schiene in der Ecke mit einem Keil zu stabilisieren so dass die Halterungen nicht mehr heraus fallen.
Der Keil war schnell entworfen und gedruckt. Ich habe die Tür wieder eingefädelt und dann mit zwei Schrauben den Keil an der Decke so befestigt dass der die Schiene an der Schwachstelle zusammendrückt. Seitdem funktioniert die Tür wieder einwandfrei. Den selben Dienst hätte auch ein Holzkeil getan, aber hey - ich habe einen 3D-Drucker!
Druck: Standardeinstellungen, PLA, keine Stützen, kein Rand.
english:
A small wedge instead of a large repair.
Our camper has a rolling door to the bathroom. It has also worked well for years. At some point, the brackets fell from the rail on the ceiling and the door was almost unmovable. After I had threaded the holders again, it worked again for a short time, then the thing started from the beginning. I looked closely at the rail. In the corner it is particularly strongly curved and there it had widened a little. As a result, the hanging brackets of the door have slipped out at this point. At first I thought that the rail needed to be replaced and that this would be a stupid repair. Until I came up with the idea to stabilize the rail in the corner with a wedge so that the mounts do not fall out.
The wedge was quickly designed and printed. I threaded the door again and then attached the wedge to the ceiling with two screws so that the rail pushes the rail to the weak spot. Since then, the door has been working flawlessly again. The same service would also have done a wooden wedge, but hey - I have a 3D printer!
Print: Default settings, PLA, no supports, no edge.