Solid light-weight Bicycle Repair Stand
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€18.99 – €23.21 net (excluding VAT)
For file: BikeStand_0.4n_0.2mm_PLA_COREONE_10h59m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €21.10 excluding VAT (range midpoint).
- Weight reported by the author
- 475 g
- Print time reported by the author
- 10.99 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Modular bicycle mount for repair, maintenance and tuning.
- Rating
- 5 / 5
- Likes
- 33
- Downloads
- 41
- Makes
- 1
- Views
- 559
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This design allows to mount the bicycle in a way, that you can still drive the back-wheel with the pedals. It allows to lubricate the chain or tune the gear-shifter easily. The triangle design provides sufficient strength even for heavy bikes. The two triangles are connected via the 2 bottom rods, adapt their length to your individual bicycle if needed. Removal of the 2 rods allows easy storage of the stand. The given indicated rod-length allows for a bottom clearance of 400mm measured from the lower side of the frame. You may just scale the rod length for more or less clearance by applying a scale factor.
Assembly instructions:
- Cut the 12mm aluminium rods according to the drawing (4x399mm, 2x220mm, 2x228)
- Start by fitting the rods in the 2 frame holders (left and right)
- The arrows on the parts do all need to point in the same direction (the front of the bike)
- Loosely fit the rod between the two corner parts but do not fully insert it yet
- Loosely fit the rods which you fitted in step 1 in the holes of the corner parts
- Carefully put pressure on the top part and wiggle the rods in place till they are fully inserted to form a triangle
- Connect the 2 triangles with the bottom rods, fit M5 screws to press against the rods if the rods are too loose in the holes and the triangles come apart.