1 / 9
USB-C Logitech Wireless Mouse Charging Dock
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Diy charging dock compatible with any Logitech mouse that is powerplay compatible. Parts are listed below.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 218
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
DIY Mouse charging dock which works with any logitech mouse that is Powerplay comatible as it uses the two charging connectors on the bottom.
Part list:
- 3D Printed parts:
- 1x Base
- 1x Coin
- 1x Body
- Electronics:
- 1x TP4056 usb-c board
- 2x ~5cm cable
- diode
- Screws:
- 1x M3 10mm
- 2x M3 16mm
- 2x M3 ring terminal
- 3x M3 nut
- Tools:
- Soldering Iron
- Screwdriver
- Hot glue gun
Assembly:
- Print all Parts
- Glue the TP4056 Board into the cutout in the base
- Soldier the two wires to the terminals right next to the usb port (Not to the battery or out terminals)
- Optional: Use a diode for extra safety incase you get the wiring wrong. (Check polaritry with a multimeter before charging your mouse)
- Put the other ends of your wires into the ring terminals.
- Insert the nut into the connector connecting body and base. (Use hot glue if the nut can spin freely)
- Connect the coin with the Body using two M3 screws, add the ring terminals (as show in the picture) and secure it with a nut on each screw.
- Screw down the Body to the Base.
- Make sure to check that the right screw is the positive and the left one is the negative terminal. (As shown in the picture)