snot — bike gear wall storage
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.84 – €4.69 net (excluding VAT)
For file: Tray for a 30mm wooden rod / tray_02mm_pla_mk3s_4h3m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.26 excluding VAT (range midpoint).
- Weight reported by the author
- 58 g
- Print time reported by the author
- 4.04 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Stylish way to hang your bike gear — glasses, shoes etc
- Rating
- 4 / 5
- Likes
- 49
- Downloads
- 133
- Makes
- 1
- Views
- 1,174
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is inspired by a commercial product that is also 3D printed but very expensive.
This design uses a 25mm wooden rod. You need two wall mounts that screw into the rod. Print the drill guide twice and slide onto the rod. Drill one hole with a 2-3mm drill and drop a small nail into the new hole to keep the rod from turning, then drill the rest of the holes. You should be able to attach the wall mounts to the rod without having alignment issues later. Use M3 wood cutting screws to fix the wall mounts to rod.
There are different step files for the mounts for shoes, glasses, a small tray, and a helmet hanger. All of these just clip onto the rod and in my tests were just snapping onto the rod without breaking and didn't move under load. You might have to play with the rod diameter if they are too loose or break when being snapped onto the rod. You can also always just slide them on from the top/bottom.
You can show the infill pattern on the tray by setting the top shell layers to 0 and using an infill pattern like ‘Adaptive Cubic’ with 25% and a 45° angle - it looks eerily similar to the original. See the .3mf file for an example.
The design is parameterised in FreeCAD, you can change the values in the spreadsheet to change the rod diameter.
I printed a few of these in matte PLA, but any material should be fine.
Have a look at the wall mount for a bike in the same design: https://www.printables.com/model/1391898-snot-bike-wall-mount