1 / 4
Samsung monitor flush wall mount — image 1
1 / 4

Samsung monitor flush wall mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Wall mount that fits a Samsung Viewfinity S5 monitor (its not a vesa mount). Can probably fit other models/monitors

Rating
0 / 5
Likes
1
Downloads
45
Makes
0
Views
198
Reviews
0

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution

Description

This is a two-part wall mount  designed for a Samsung ViewSonic S5 monitor (probably fits other models/makers). The parts are:

  • monitor_mount: attaches to the monitor (the one with the two screw holes).
  • wall_mount: attaches to the wall using three screws.

Required Hardware

  • For the monitor_mount:
    • Use the original two screws the come with the monitor.
    • If you dont have them, the screws should have the following characteristics:
      • Head: 8.5 mm wide × 3 mm tall
      • Shaft: 4 mm wide × 12 mm long
  • For the wall_mount:
    • 3 wall screws with:
      • Head: ~8 mm wide and <4 mm tall (to fit countersinks)
      • Shaft: <4.8 mm wide
  • 3 wall plugs (I used 8 mm diameter plugs)

Assembly Instructions

  1. Attach monitor_mount to the monitor:
    • Slide it into place with the flat side facing the back of the monitor.
    • The two extrusions should align with the holes in the monitor’s recessed mounting area.
    • Secure it using the original screws (or compatible ones as specified above).
  2. Mount the wall_mount:
    • Ensure the countersunk holes face outward (toward you).
    • The lip should face upwards — this allows the hook on the monitor_mount to sit properly.
    • Mount it level to evenly distribute the monitor’s weight.
  3. Final Steps:
    • Plug in your cables.
    • Slide the monitor onto the wall_mount.

Print Settings

These are the settings I used:

  • Supports: Painted supports only for the two extrusions on the monitor_mount
  • Print orientation: Printed standing up (so layer lines are vertical when mounted for maximal strength)
  • Perimeters: 4
  • Material: ASA (recommended for strength — PLA may be too weak)
  • Infill: 30%, Gyroid pattern
  • Layer Height: 0.15 mm

Tags