FlashForge Adventurer 5M (AD5M) cooling ducts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement duct for AD5M
- Rating
- 5 / 5
- Likes
- 79
- Downloads
- 368
- Makes
- 4
- Views
- 2,490
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
Yet another cooling duct for AD5M. Fairly lightweight, under 20 grams printed with the modifier from PET-CF. The first model is tested only with AliExpress aftermarket nozzle, the 2nd one is for Original nozzle and Phaetus Conch.
Modifier options:
- 0 top shells
- 0 bottom shells
- 1 wall loop
- 8-15% infill is pretty good
- You can play around with infill patterns to find something you like, i used 10.5% and honeycomb in the picture above.
You can always print this without the modifier, it's just there incase you want to play around a bit with the design :)
This uses 5x2mm magnets. Make sure to put them the right way, good tip is to put them to the toolhead first and mark the correct side with a marker so they'll attach to eachother :)
Use a filament that's heat resistant, i had ABS melt over time so something like pa6-cf/gf, pet-cf etc. preferred.
------------------------------------
NEW!
- Added 2nd model that should point the airflow more to the center, i noticed the old one pushes more air to the back. This one is tested with the original nozzle and the conch, fits nicely to those.