UPDATED: Meshtastic XIAO ESP32S3 & Wio-SX1262 Kit with the L76K GNSS Module adaptation
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an adaptation to utilize the XIAO ESP32S3 & Wio-SX1262 Kit with the L76K GNSS Module by SeeedStudio XIAO.
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 64
- Makes
- 0
- Views
- 1,139
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I really enjoy this enclosure as it is tough, light, and adaptable. I would also like to test other radios, since the case leaves some room for exploring. I used double sided tape or hot glue to keep the chips in place.
EDIT: After testing many enclosures for a multitude of radios, this case is by far my most favorite in terms of the below. HATS off to Optimal Objects for this excellent enclosure and system:
Quick swap 18650 battery changes in the field!
External antennas for better range and adaptability
Separate antenna racks for interchangeability
Viewing screen protected by durable and scratch resistant glass
Room up top for external on-off toggles and user buttons if desired
I uploaded the entire set, which includes an inset bevel for the glass which is pictured, updated top of shell, and antenna bracket.
- I use an INA219 voltage meter, which is useful. The meter allows the user to view voltage state on-board as the S3 cannot read battery percentage to my knowledge. You can also custom edit your own shell and antenna bracket to install a user button and toggle switch.
To wire with the INA219 Voltage Meter-
BATTERY and ON-OFF SWITCH: Connect the battery (+) to the HIGH SIDE solder pin hole on the INA219 Vin (+), then run a wire from the high side Vin (-) to the on-off switch, and then to the battery (+) pad on the underside of the S3 chip. The battery (-) gets wired directly to the battery (-) pad on the underside of the S3 chip.
THE REST: Connect all corresponding leads (the first four starting with GND, VCC, SDA, and SCL) from the INA219 to the .96 OLED, and then connect those leads from the OLED to the S3 corresponding solder pin holes as GND, 3V3, SDA and SCL.
Connect the GPS L76K RX and TX to the Seeed S3 RX and TX, with the 3V3 and GND attached to whatever 3V3 and GND is convenient on the screen, INA219, or Seeed S3.
THE BUTTON: One pin is wired to GND on the OLED Screen, or GND on the S3. I chose the screen for ease. The other pin of the tactile button is connected to GPIO4 on the S3 chip.