Fridge / Refrigerator Shelf for Frigidaire (Single Print, 400mm Bed Required) Several Sizes Available
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Thanks to @Kemmotar for the excellent design of the original. I made a few different sizes, and decided to put my…
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 209
- Makes
- 0
- Views
- 1,696
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Thanks to @Kemmotar for the excellent design of the original. I made a few different sizes, and decided to put my Ender Extender kit to work. The result is marvelous.
30% Infill was used here, in Cubic Subdivision arrangement. I only did two bottom layers and two top layers, and a single wall width. Now, keep in mind, you'll need to double those numbers if you're using a normal 0.4mm nozzle; I was using a 0.8mm nozzle, so a "single wall" for me is 0.8mm, not 0.4mm. I printed in 0.4mm height, with dynamic heights enabled in Cura (variance allowed: 0.8, step size: 0.4).
Supports required, but, I set my overhang to 50 degrees, set my supports to "gyroid" to safely make it to height, and all was well for those little overhangs on the sides.
I love it. My original print was in a solid orange, but... my cable feeding my extruder failed at 80%. GAH.
Works well, thanks! (It has a little bit of wiggle room on the left and right -- not enough to be concerned by or anything. One might size up the X-axis by 1% or 2% according to your fridge's exact dimensions. I left it alone because every nook and cranny inside a fridge is ROUND, so its hard to know if it'll be perfectly snug, or need 4 hours of sanding. ^_^)
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.32~0.48
Infill:
30%
Filament: COEX PLA Mystery (Yellow / Clear)
Category: Kitchen & Dining