Duet Toolboard 1LC V1.3 Mount for Voron Stealthburner

I designed this mount to attach a Duet Toolboard 1LC V1.3 to the Voron Stealthburner. I found that the board doesn't fit very well on Voron so, after several iterations, I came up with this design to locate the board in the sweet spot to prevent interferences during movement.  I also wanted to be able to install the mount without taking the stealthburner apart. NOTE: This design is for the two hole cable chain.

This design balances the location to give clearance with the belts at X0,Y0, prevent contact of the board with the back cable chain at Y0, allow full motion in the X direction without the cable chain hitting the side panel at max X values, and keep the board as low as possible while preventing the wires underneath the board from hitting the X cable chain when the chain rides up at large X positions. There are only a few mm of clearance in several of these directions so check for interferences by manually moving the printhead. If necessary, you can flex the mount a little bit if you need extra clearance in a certain direction. The mount also has cuttoutsto give clearance for the pins on the board.

To install: 

Print the mount in the orientation shown in the attached image

Install qty(7) M3 Brass Inserts per the attached image

Install the Duet Toolboard 1LC onto the hexagonal section of the mount using qty(4) M3 bolts.

Remove the two bolts attaching the cable chain mount on the back of the stealthburner and attach this mount instead. Adjust the cable chain length as necessary to keep it from running into the acrylic side panels at the max X position value.