1 / 3
Drybox Filament Guide Using PTFE Tube (10mm Nut)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed @mp42's PTFE Tube throughull guide. I needed smaller sizes just like @pango3001. Multiple tolerance choices.
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 56
- Makes
- 2
- Views
- 182
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Smaller Size Fittings (Scaled down to ~56% original: 18mm nut to approximately 10mm nut). Very easy to install using x2 10mm Sockets, one on each side. Drill 6.35mm (¼ inch) to 6.5mm hole in dry box for this throughull fitting, if necessary apply glue/silicon for better air seal.
- Three Fitting Tolerances (variable PTFE Tube bore 4.0mm, 4.05mm, 4.10mm)
- Three Nut Tolerances (from Tight, Std, to Loose)
*note: if the 4.10 bore hole is still too tight, bore it out with an 4mm drill bit to cleanup seam zits.
Nozzle & Filament:
- 0.4mm nozzle
- PETG
Orca Print settings:
- 0.1mm Layer Height
- 100% infill
- 3 wall loops (irrelevant if infill is 100%)
- Seam Position: random