1 / 6
Tilt and rotate extension for Foldable telescopic snap lock camera mini tripod
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A special adapter for the @Lukes3D telescopic tripod that allows for tilt, rotation, and portrait camera mode.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 55
- Makes
- 0
- Views
- 305
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
About:
@Lukes3D telescopic mini tripod is great, but I found out that it's not possible to rotate or tilt my camera with it. So that's why I designed this model - special extension which gives you more flexibility while using the tripod.
Features:
- Rotate and tilt camera
- Special bolt for adjusting strength
- Portrait mode support (depending on your camera you may need to shorten one leg in order to keep it stable)
Parts:
- Bottom screw support - attaches extension to the tripod
- Main knob - base
- Tilt lever - holds the camera
- Bolt - adjusts strength of tilting
- Rubber pad bottom, Rubber pad side - keeps rotation and tilt stable, print with TPU
And screws:
- 1x M3x20
- 1x M3x10
- 1x M3x14
- 4x M3 nut
Assembly:
Read the step-by-step instruction or just look at the animation below:
- Place a nut in the Bottom screw support
- Insert the Bottom screw support from the bottom of Top plate (top part of @Lukes3D tripod)
- Place Main knob on the top of Top plate, with Rubber pad bottom between
- Insert M3x20 screw into the middle hole in Main knob and tighten it
- Then, place Rubber pad side, one of each side of Main knob (look at the rows)
- Put on Tilt lever carefully, paying attention that the Rubber pads do not fall out
- Insert next two hex nuts into remaining holes at the top of Main knob
- Insert the M3x10 screw into the bigger hole in Tilt lever and tighten it
- Take a next nut, and screw it into the M3x14 screw (to the end)
- Take this screw and insert it into the Bolt (the side with hexagonal hole)
- Insert this piece into the second hole in the Tilt lever and tighten it
- Done!
