Tilt and rotate extension for Foldable telescopic snap lock camera mini tripod

About:

@Lukes3D telescopic mini tripod is great, but I found out that it's not possible to rotate or tilt my camera with it. So that's why I designed this model - special extension which gives you more flexibility while using the tripod. 

Features:

• Rotate and tilt camera
• Special bolt for adjusting strength
• Portrait mode support (depending on your camera you may need to shorten one leg in order to keep it stable)

Parts:

• Bottom screw support - attaches extension to the tripod
• Main knob - base
• Tilt lever - holds the camera
• Bolt - adjusts strength of tilting
• Rubber pad bottom, Rubber pad side - keeps rotation and tilt stable, print with TPU

And screws:

• 1x M3x20
• 1x M3x10
• 1x M3x14
• 4x M3 nut

Assembly:

Read the step-by-step instruction or just look at the animation below:

1. Place a nut in the Bottom screw support  
2. Insert the Bottom screw support from the bottom of Top plate (top part of @Lukes3D tripod)
3. Place Main knob on the top of Top plate, with Rubber pad bottom between
4. Insert M3x20 screw into the middle hole in Main knob and tighten it
5. Then, place Rubber pad side, one of each side of Main knob (look at the rows)
6. Put on Tilt lever carefully, paying attention that the Rubber pads do not fall out
7. Insert next two hex nuts into remaining holes at the top of Main knob
8. Insert the M3x10 screw into the bigger hole in Tilt lever and tighten it
9. Take a next nut, and screw it into the M3x14 screw (to the end)
10. Take this screw and insert it into the Bolt (the side with hexagonal hole)
11. Insert this piece into the second hole in the Tilt lever and tighten it
12. Done!