X100 1/64 Scale RC Excavator Tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
X100 1/64 RC Excavator Tray
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 0
- Views
- 263
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
X100 1/64 Scale RC Excavator Tray
Simple 245 mm x 245 mm x 50 mm deep tray for the X100 from Nano Nation RC
Printed in about 11.5 hours at 120 mm/s with PLA+, .2 mm layer height, 20% rectilinear infill on an Anycubic Kobra 3 (250 mm x 250 mm build plate) - I had made it slightly smaller than my build plate in case it would over run or get too close to the edges.
Mine warped a bit at the corners but only because the first color ran out overnight so keep this in mind - maybe use a brim just in case. Took several attempts to finish but I think that was due to my printer, 90 mm/s might work better depending on your printer - I usually print at 90 but the estimate was 19 hours.