X100 1/64 Scale RC Excavator Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
X100 1/64 RC Excavator Tray
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
X100 1/64 Scale RC Excavator Tray
Simple 245 mm x 245 mm x 50 mm deep tray for the X100 from Nano Nation RC
Printed in about 11.5 hours at 120 mm/s with PLA+, .2 mm layer height, 20% rectilinear infill on an Anycubic Kobra 3 (250 mm x 250 mm build plate) - I had made it slightly smaller than my build plate in case it would over run or get too close to the edges.
Mine warped a bit at the corners but only because the first color ran out overnight so keep this in mind - maybe use a brim just in case. Took several attempts to finish but I think that was due to my printer, 90 mm/s might work better depending on your printer - I usually print at 90 but the estimate was 19 hours.