Rack Cable Management – Velcro & Clip Lock

I made a remix of the Cable Management Base (rackmountable) by Ascardia using Velcro, because installing the cage nut was a real pain You need to be an expert to do it or use special tools to avoid hurting your fingers.

After doing some research, I found a model that uses a lockable clip Rack Cable Guide with Locking Insert by Nvncibl, which simply snaps into the rack.

In my remix, there are two versions: one with a built-in support, and one without, so you can add your own.
Depending on the rack’s tolerances, the locking pin may not be necessary.

No special print settings are required for this model but if it’s used in a data center, I recommend printing it in ABS or ASA to resist the heat in hot corridors.