Sovol SV08 Creality Nebula Camera Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount for a Creality Nebula Camera in the SV08
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 75
- Makes
- 1
- Views
- 523
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
I wanted to have a better camera in my SV08, so I redesigned the original Sv08 camera mount to fit the creality nebula camera in the original camera position.
You can pull out the original camera cable and run the cable of the nebula camera in its place or you can connect the plug inside the nebula camera tor the original wiring. For that you have to open the back of the camera to reveal a JST plug on the PCB, wich you can then connect to the original harness.
At first I had the mount designed after the original mount of the nebula camera but it was a bit to low, for the first layers because I have my bed raised for a Taco Bed Fix. For normal bed heights it should be fine though.
V2 raises the camer by 5mm but needs a hole to be drilled in the housing of the camera to screw it to the mount.
📦 Bill of Materia (BOM):
For V2:
1x M3 heat set insert (3mm height, 5mm OD)
1x M3x6 screw