WAGO clamp opener / pliers
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.71 – €0.86 net (excluding VAT)
For file: pliers_0.4n_0.15mm_PLA_MK4S_38m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.78 excluding VAT (range midpoint).
- Weight reported by the author
- 13 g
- Print time reported by the author
- 37.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Handy pliers for opening WAGO clamps without damaging the wires or your nails.
- Rating
- 5 / 5
- Likes
- 76
- Downloads
- 171
- Makes
- 2
- Views
- 2,101
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About:
These pliers are designed specifically for opening WAGO 221 (and similar) clamps.
Opens clamps easily than by hand when a wire is already inserted.
The model is optimized for support-free printing, minimal material use, and a short print time.
Dimensions & Compatibility:
- Tested on Prusa MK4S printer
- Recommended materials: PLA or PETG
- Includes ready-to-print G-codes
- Two variants STL - with smaller and larger tolerances
Print settings:
- 2 perimetres for PLA
- 3 perimeters for PETG
- 15% infill is sufficient
- Print orientation as in the provided file
- Prints without supports, 0.15 mm layer height, 0.4 mm nozzle
If you have any ideas or feedback about the model, please let me know.