Space Saving - Outlet or Light Switch Mounted -Tooth Brush Holder

The “Space Saving - Outlet or Light Switch Mounted -Tooth Brush Holder” attaches to the right or left of a decorated or plain electric socket or light switch cover.  The decorations on the covers are simple Greek inspired floral stencils.

This toothbrush holder is designed for a Philips Sonicare toothbrush with charger.  The space below the toothbrush is used to organize & hide the power cable for the charger.

The other two holes can hold a razor and toothpaste, as pictured below.

There are a total of 12 face plate designs uploaded, that allow you to mount on the right or left of each plate.  One design has no decoration, and the other has a “positive” greek style stencil border.  All the plates have a female dovetail to accept the male dovetail from the toothbrush holder.

Non-dovetail face plates can be found at the following link:

https://www.prusaprinters.org/prints/145370-electric-socket-and-light-switch-covers

Three toothbrush holder designs are uploaded and pictured below.

BLUE → Mounts on Right side

ORANGE → Mounts on Right or Left side

GREEN  → Mounts on Left side

Printing & Design Notes:

The dovetail design is a tight fit, because of the 0.2mm of clearance.  I was able to attach and un-attach the toothbrush holder by repeatedly tapping on the edge of the face plate with the plastic end of a screw driver.

It is important to remove all the printing support material from the dovetail.  I used a box cutter blade to clean it up.  Pictured below are the on edge views of the dove tale design and the individual prints used in the above picture.

If you decide to model your socket or light switch cover, the dove tail profile I used is shown below (units in mm).