1 / 9
SUP-Canoe-Kayak Paddle Handle w- 8mm Push Pin Slot and Hole — image 1
1 / 9

SUP-Canoe-Kayak Paddle Handle w- 8mm Push Pin Slot and Hole

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remixed SUP-Canoe-Kayak Paddle Handle to add 8mm Push Pin hole-slot for positive retention, 8mm push pin printable

Rating
0 / 5
Likes
11
Downloads
53
Makes
0
Views
223
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Remixed SUP-Canoe-Kayak Paddle Handle to add 8mm Push Pin hole and slot for easy assembly - 8mm push pin printable or sold separately (see link below)

Geometry


Choose: 26.95mm OD
OR: 26.2mm OD

Slot is 65mm deep into the handle

Both are in Orca Slicer but be sure to pick the correct diameter for your paddle tube. 

Print Settings

Works best in ASA

I used 0.12mm layer height, Arachne wall generation, 0.4mm nozzle, 10 walls, 30% infill for the top of the handle. Remember your life depends on this working, so don't skimp on the wall thickness! This is essentially 100% infill where it counts. 

For Supports, you can send it as is if you want with a brim, but I opted to add side stabilzing supports and for the overhangs as it goes up to the top of the handle. See image attached for support structure. Supports are in the .3mf file (Orca 2.3.1)

Remember ASA can be vapor smoothed - but ONLY with proper PPE (filtered sealed mask - not paper N95 etc.) and open air environment.

Notes

Link for 8mm Push Pin (I am no longer an affiliate)

https://amzn.to/4o4kuXb

Check out my printable model for 8mm and 6mm push pins

Tags