5015y Anniversary MK1 for Creality K1, K1C, K1SE, K1 MAX
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
5015 fan lightweight head cover for Creality K1, K1C, K1SE, K1 MAX with Creality K2 PLUS hotend with K1/Volcano nozzles
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 111
- Makes
- 0
- Views
- 1,101
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This 3D model is still under development!
##########################
Update 28.10.2025
Aded models for Cartographer 3D mount for Stock and BCJ X Carriages
##########################
Hi everyone! I made 5015y Anniversary MK1. This is a redesigned version of the part cooling duct for using a 5015 blower fan.
Original version: https://www.printables.com/model/1445684-5020y-anniversary-mk1-for-creality-k1-k1c-k1se-k1
It is the 5015 fan lightweight toolhead cover for Creality K1, K1C, K1SE, K1 MAX with Creality K2 PLUS hotend for K1/Unicorn and Volcano nozzles.
There are versions available for the K1 and Volcano nozzles and for the standard carriage and the BCJ carriage.
How to install Creality K2 Plus Hotend on Creality K1/c/max/se: https://telegra.ph/Ustanovka-hotenda-ot-Creality-K2-Plus-na-Creality-K1cmaxse-05-13-2
The video features the 5020 fan, but it works the same with the 5015:
Printing settings:
This 3D Model was printed with ASA and ABS filaments.





Klipper settings:

BOM:
1x 24V 5015 blower with ball bearings;
1x N-channel field-effect transistor (MOSFET) for 2 wire fans. Bipolar PNP and NPN transistors will not work;
2x heat-set inserts M3 (4.6-5mm OD);
3x screws M3x25 for mount fanduct and fan;
1x M3 screw from stock toolhead to mount fanduct from side;
2x M3x6 screws for toolhead top BCJ mount;
or 2x M3 stock screws for toolhead top Stock mount.
Assembly Guide
Prepare the Fan:

Melt the heat-set inserts into the fanduct, as shown in the images.


Wiring: Solder the wires to the fan and the MOSFET, following the provided connection diagram.
Installation: Install the cover and connect the fan wires.
Mounting: Attach the fan to the cover using screws.

2-Wire Fans Only (Noise Reduction): To eliminate PWM noise, open the printer.cfg file, locate the output_pin: fan0 section, and change the cycle_time value to 0.1000.
This is only a small part of all those test models that I modified :)

I'd be very grateful if you could buy me a coffee 
It would motivate me to continue working on my projects, of which I've already accumulated quite a bit. I'd appreciate any criticism in the comments.
Thanks everyone.
