Whirlpool/Maytag Fridge Shelf Support Hooks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement shelf support hooks for multiple brands of refrigerator. Designed from measurements from a Maytag RSW2200E.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 19
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
This is a mix of me learning to model structural pieces on FreeCAD and to generally build out a stronger shelf clip since every replacement one I've bought online has broken over time at the same point along the layer lines. Also, I was buying clips for about $20 to $30 a pair online, and got tired of it.
As far as I'm aware, based on the fridge model I based these off of, they should be suitable replacements for Whirlpool/Maytag model 67043-5 and 67043-6. There are other models that these can replace, but these are the only ones I can personally confirm.
Tested on an Elegoo Centauri Carbon w/ 0.2mm and 0.4mm nozzles in PETG, strength settings of 6 walls and 70% infill. Still new to 3D printing, so not sure if these settings are too much or too little, but the pieces feel really solid. Recommend printing with the side faces of the hooks down on the bed with supports.
Center hole is for a heat-set threaded insert for an M3 x 6 screw. The tolerances were modeled in such a way where the screw isn't fully necessary. I will say that my fridge shelves had some variance in the sides where the hooks go, so you might need to file down an edge of the hooks or shove the back of the hook into place.