beltreroute + better center of mass + more Z height
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v3.0
This mod requires some other way to mount electronics!
i recommend the electronics tower, and optional mod i made for it to mount the skr if you dont have a Xbuddy case
https://www.printables.com/model/1415732-prusawire-electronics-tower
https://www.printables.com/model/1464165-skr-mini-e3-v3-printable-case-pi3b-backplate-mods
You also need to mount the X assembly upside down so the belts can get routed on the top of the extrusion
For Y i used the original Mk4 Rod holders, and this idler and motor mount:
https://www.printables.com/model/792098-prusa-mk3-y-axis-belt-tensioner
https://www.printables.com/model/990567-mk3-y-axis-fixed-belt-holder
https://www.printables.com/model/1063-prusa-i3-mk3-y-axis-motor-mount
For this mod you have to adujust the configs, and invert the direction for the X and Z stepper!
make sure to test the new limits i was able to easily get X250, Y220 and Z 200
endstop positions also need to be adjusted depending on the motor mount for y used
you may also need to recheck if 0x0 is still matching to make use of the faulty zones for the bed magnets ( or switch to einarjh implementation of 5x5 mesh without any faulty zones!
https://github.com/Positron3D/prusawire-klipper-config/blob/main/probes/super_pinda__einsy_rambo.cfg
Bill of Materials:
Motor Mount left:
6x M3x30 mm SHCS
2x M3x35 mm SHCS
2x M3x5 mm SHCS
1x M3x12 mm SHCS
7x M3x0.5mm shim/washer
4x F623 Bearing
4x Voron M3 Heatsets
Motor Mount Right:
6x M3x30 mm SHCS
2x M3x35 mm SHCS
2x M3x5 mm SHCS
1x M3x12 mm SHCS
7x M3x0.5mm shim/washer
4x F623 Bearing
4x Voron M3 Heatsets
Idler Left:
1x M3x35 mm SHCS
1x M3x12 mm SHCS
16T 3mm Bore Pulley OR Bearing stack 2x F623 and some M3x0.5mm shims (gotta figure out the amount of shims yourself)
Idler Right:
1x M3x35 mm SHCS
1x M3x12 mm SHCS
16T 3mm Bore Pulley OR Bearing stack 2x F623 and some M3x0.5mm shims (gotta figure out the amount of shims yourself)
Frontgrill Spacers:
8x M3x12mm SHCS
4x Voron M3 Heatsets
Frame Spacers:
8x M5x55 BHCS (better M5x60 or 65mm depending on MK4 or MK3 you may need longer than 55mm minimum. I have used M5x55 on a MK3 frame without issues)
Of course hardware to use Stock-Y and Electronicstower since there will be no space left below the bed for electronics as well as slightly longer belts than stock Prusawire
For assembly please look at the provided cad