1 / 3
The Fang Filament Spool Holder: Uses your old v-slot wheels for friction free unspooling — image 1
1 / 3

The Fang Filament Spool Holder: Uses your old v-slot wheels for friction free unspooling

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

If your filament spool holder tugs back too hard sometimes, this could be an answer. I created it in an attempt to…

Rating
5 / 5
Likes
6
Downloads
30
Makes
0
Views
458
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution

If your filament spool holder tugs back too hard sometimes, this could be an answer. I created it in an attempt to rule out spool friction issues in Voron Issue 6. It seems to help.

This thing uses your old worn out v-slot wheels to unspool your filament without friction. It can mount to your frame with a M5 bolt and hammerhead nut (or slide/roll in) or you can use a drywall screw to attach it nearby as pictured.

It may not work well in situations where there are very large retractions that can send your spool spinning mercilessly inviting possible tangles. It's worked well for me for direct drive (eg, Voron afterburner) hotends that don't need to retract much or send the spool spinning.

Assembly is not terribly complicated. Just snap two vslot wheel bearings into the obvious spots. It's a tight fit but most filaments will tolerate your forcing them in. (tested very well with ABS)

Print Settings

Printer:

Voron 1.8 300

Rafts:

No

Supports:

No

Resolution:

200

Infill:

40% cubic subdivision

Filament:

Generic ABS

Black


Notes:

Should print without supports on any reasonably well configured printer. If this gives you trouble, post a comment and I can provide a less curvy version.

How I Designed This

Category: 3D Printer Parts

Tags