"Mojave Breeze" Chamber Heater for Sovol Zero (and others)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple chamber heater/carbon filter combo to keep it toasty like the Mojave in your chamber.
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 76
- Makes
- 0
- Views
- 1,274
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
NOTICE: USE OF AN AUXILIARY CHAMBER HEATER POSES A RISK TO LIFE AND PROPERTY IF USED INCORRECTLY. BY DOWNLOADING THESE FILES YOU ACKNOWLEDGE THAT YOU ARE AWARE OF THESE RISKS AND AGREE THAT I AM IN NO WAY RESPONSIBLE FOR ANY DAMAGE YOU CAUSE TO YOURSELF, YOUR PRINTER, YOUR DOGS&CATS, YOUR MOM'S BASEMENT, ETC. IF YOU DO NOT UNDERSTAND THIS RISK OR DO NOT FEEL CONFIDENT IN YOUR ABILITY TO USE THIS HEATER SAFELY, DO NOT DOWNLOAD IT.
Printing Note:
Although none of the parts is “structural," per se, you will likely be running this heater between 100-120C and you will need a material that can withstand those temperatures. I recommend some variety of PC (vanilla, PC-CF, ezPC, whatever) as it typically has a HDT in that range. Check the spec sheet for your preferred plastic to ensure it will survive. I have been using this design for more than 250 print hours and have not suffered any material melting or other malfunction with the heater.
BOM:
- 6x Voron Spec Heat Inserts
- 6x M3 screws (any head) ~8mm long
- 24v/100W DC (NOT AC) PTC heater
- GDSTime 7530 blower fan
- Carbon pellets
- NTC100K thermistor
- Heat resistant zip ties
Assembly and Setup:
- Print Body and Lid
- Add heat set inserts (should be obvious where, holes are sized 4.5mm)
- Fill front reservoir with carbon pellets
- Zip tie thermistor to front cage of heater
- Wire heater to a free hotend mosfet on your motherboard (stock Sovol boards and others may not have extras - check first)
- Wire thermistor to free thermistor header on your motherboard
- Config
- Validate safe function and confirm that the fan turns on when the heater goes on. This is essential to not melting the housing.
- Run PID_CALIBRATE for the target temp of your choice. I recommend 100C.
Config:
Be aware that the pins referenced below are specific to my printer and motherboard. DO NOT SIMPLY COPY/PASTE THE BELOW CONFIG. You must check to ensure that you are identifying the correct pins for your system.
[verify_heater chamber_heater]
max_error: 1000
check_gain_time: 1200
hysteresis: 5
heating_gain: 2
[heater_fan chamber_fan]
pin: PA4
max_power: 1.0
cycle_time: 0.015
kick_start_time: 0.5
heater_temp: 35
heater: chamber_heater
heater_temp: 30 #
[heater_generic chamber_heater]
gcode_id: E
heater_pin: PF9
max_power: 1
sensor_type: Generic 3950
sensor_pin: PC5
#pullup_resistor: 20000
control:
pid pid_kp: 32.341
pid_ki: 1.251
pid_kd: 209.001
#max_delta: 1.0
min_temp: 0
max_temp: 200