Minolta XD7/XD11 Film Indicator Fixing

If you're restoring or repairing a Minolta XD7/XD11, you might need to remove the film indicator window in order to better replace the original grips/leatherette. This involves cutting the plastic nubs that go through the door, as the original was attached permanently by squashing or melting the ends of these.

This little doodad makes it easy to reattach the film indicator afterwards, and allows for the feet of the film pressure plate in the design. Place this on the inside of the door, flush cut the remaining parts of the original pins on the indicator and carefully drill a millimeter or two down (I used a 2.8mm bit in a hand drill for this), then after checking it lines up correctly you can put a small amount of glue in the drilled holes to attach to the 3D printed part.

I printed mine in some leftover Elegoo black PLA and it's a perfect fit for the holes. Take care when removing it from the plate as it's somewhat delicate. 3 wall loops, inner/outer/inner wall print order, and 100% infill are the key settings I've used, which might affect the dimensions. Feel free to experiment with your own - this takes less than 2 minutes to print.