Poop / Waste Chute – K2 PRO (CFS front-redirect), symmetric
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Redirects CFS purge (“poop”) to the front of the K2 PRO for easy clean-up.
- Rating
- 5 / 5
- Likes
- 52
- Downloads
- 664
- Makes
- 3
- Views
- 1,751
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Two versions :
Redirects CFS purge (“poop”) to the front of the K2 PRO for easy clean-up. Tight mechanical slack by design; a light sandpaper pass may be needed.Default right-side install; mirror in slicer for left.
Thermal & airflow note
The chute angle was computed to be as steep as possible without obstructing the PSU ventilation. Blocking that vent can raise local temps and soften PLA over time.
Flow behavior note
Because the chute prioritizes steep angle without covering the PSU vent, a few small purges may occasionally pause partway down instead of falling straight into the bin. They typically drop within a few minutes due to printer vibrations or when the next purge nudges them (inertia restart).
Print recommendations
Chute parts: PLA; 0.2mm layer height; minimal support
Bins: PLA or PETG work fine; 0.28 mm layers; 2–3 walls; 15–20% infill. (Bins are not near the PSU vent; choose PETG if your enclosure runs warm.). Bigger bin available
Assembly (see Tutorial photos)
1. Mount Part 1 in place (both screws).
2. Seat Part 1 onto Part 2 with a slight angle (intentional assembly tilt), then level and slide fully home.
3. Insert Part 3 and reuse the existing screw to lock Part 3 (do not over-torque).
4. Place one of the bins beneath the chute outlet.Fit note
Interfaces are intentionally tight. You may need a quick sandpaper pass on the mating tabs/slots, only on the contact areas.
