Model Paint Stand

Modular and expandable model paint stand for Vallejo, Army Painter and other 25 mm dropper bottles.

• Holds dropper bottles in upright and upside-down position firmly

• Has a wide window for the lables of the bottles

• Baseplate holds any leaking paint and keeps your desk clean in case

• Modular and expandable

• Three ways of mounting

• Very versatile and nice design

Easy to print:

Just place the parts upright as they are on your print bed (see picture). NO SUPPORTS NEEDED!

Infill:
6x1 bank can be printed with only 5% infill.
Other parts are best printed with 10% infill.

Easy to assemble:

All parts fit together by sliding them into the vertical and horizontal rails. Vertical and horizontal slides have different sizes, so you can't mix them up or orient the parts wrongly.

When using the angled connector for desk space saving, just turn the baseplate 180 degrees around to have the larger tray located at the front. This is to ensure propper stand.

Assembling:

1. slide two connectors to the bottom of a 6x1 bank

2. slide the bank assembly onto the baseplate

3. add connectors to any additional bank

4. slide the additional bank assembly into the vertical rails on the back side of the previous bank

5. make sure you push each bank completely down in the vertical rails of the previous one to make the floor of the bank even with the top of the previous one. This locks the horizontal rail and holds everything firmly together.

Wall mounted:

• Use at least 2 connectors with wall mount

• If using more than 4 banks stacked you may also use wall mounts at the back of the lowest bank. This will help supporting the weight of the paint bottles.

• To set the scews/nails you can use the vertical rails at the back of the top most bank as an guide.