dumalscoBOX - CoreONE Top Enclosure with MMU Mounting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Custom CoreONE top enclosure with modified MMU3 mounting.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 24
- Makes
- 0
- Views
- 303
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
Model Description
This is my first attempt at designing a custom enclosure for the top of the CoreONE, as well as my interpretation of an alternative method for mounting the MMU3 on top of the CoreONE while keeping everything enclosed. Although this is still a relatively early and somewhat rough model, I have successfully printed and assembled most components, and the overall fit and function are promising. There is certainly room for refinement, but this represents the initial concept I envisioned when I purchased the MMU3. I wasn’t a fan of the enclosed MMU3 mounting kit offered by Prusa, especially since I use separate dry-box filament storage feeding into my buffer and MMU3.
This design reuses the existing CoreONE top panel, which mounts directly onto this enclosure. It also accommodates the original CoreONE smaller side panels (purchased from Prusa), although custom-cut plexiglass panels can be used as an alternative.
Included Components
dumalscoBOX Frame
- Four main corner frame pieces, each featuring alignment dowels and integrated brackets designed for M3 hardware.
- Bottom cutouts sized for 10×20×3 mm magnets, allowing the enclosure to magnetically mount to the top of the CoreONE frame.
dumalscoBOX Panels
- Left Side Panel – Provided in two pieces. These can be printed and mounted using M3 hardware. Alternatively, a plexiglass panel may be substituted (mounting holes may require drilling).
- Rear Panel – Provided in two pieces. These can also be printed and mounted using M3 hardware. Plexiglass can be substituted here as well.
Note: I have not yet printed or tested the rear panels.
dumalscoBOX – MMU3 Mounting System
- Mounting Brackets – Left and right brackets to position the MMU3 above the printer. I used the original data/power cable and the original PTFE tube between the MMU3 and the Nextruder.
- MMU3 Rear Plate – A rear pass-through plate for routing the five PTFE tubes from your filament buffer to the MMU3. This secures the tubes neatly and allows the top enclosure to be removed without disconnecting any tubing. This plate came from a different model somewhere at some point, I don't remember where. It was modified to attach to the MMU mounting brackets and fit within the overall frame.
Printing Recommendations
- Material: PETG (Prusa Jet Black used for my prototype)
- Infill: Most parts: 15%, MMU3 brackets: 50%
- Orientation: Frame corners printed lying flat on one side to minimize supports
- Bed Adhesion: A brim is recommended for sharper edges on main frame pieces
- Layer Height: 0.20 mm Structural profile
Assembly Instructions
Assemble the four frame corners using the alignment dowels and secure them with M3 hardware.
Attach the printed or plexiglass panels using M3 fasteners. Drill any holes as needed to suit custom panels.
Glue the 10×20×3 mm magnets into the recessed cutouts along the underside of the frame. Once installed, the enclosure attaches securely to the top of the CoreONE.
To access the MMU3 or internal components, simply lift the enclosure off the magnets—no disconnecting of tubes required.
I welcome any feedback, modifications, or remixes. Enjoy, and I hope this enclosure helps improve your CoreONE + MMU3 setup!
