1 / 4
BT2 battery voltage checker with ring (0.28inch Screen) - Snap fit
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I have lost quite a few of them...wanted to have them secured around my neck!
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 3
- Makes
- 0
- Views
- 63
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
I had bt2 battery checkers but I kept losing them…they were small and let's say I was not the most careful with them!
I got inspired from this model: https://www.printables.com/model/13930-1s-battery-voltage-checker-ph20 by @LCruz3D
Decided to design a new one with a ring and a different screen holder. Hope it can help you too not losing them.
Print:
- PLA 12% infill
- No support
- Just assemble
How to assemble:
- Get a 0.28 LED screen voltmeter and solder to the BT2 connector
- I suggest to put in place the BT2 with the wires soldered through the BT2 hole (it is quite tight fit so it doesn't move)
- then solder the voltmeter screen
- Insert the screen in the top part…
- then press it on the bottom and voila!
Note: the fit is quite tight, you shouldn't have to add glue…but you never know how it will print on your machine ;-0