Wavy double-layered Christmas bauble
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Double-layered geometric bauble with thin wavy structure
- Rating
- 0 / 5
- Likes
- 51
- Downloads
- 128
- Makes
- 0
- Views
- 547
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Winter & Christmas & New Year's
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I quickly designed this bauble a while ago to serve as a test print for experimenting with overhang settings on thin skinny prints. But after having looked at it for a while now, I kinda started liking the look more and more as a decorative object. So I have decided to share it.
Printing
The whole point of this design was to be challenging to print without supports. It is possible to do so, but you will likely struggle with surface quality on overhangs facing away from parts fan and stability of the thin parts towards the end of the print. So, unless you are specifically interested in experimenting with settings, I recommend you print this with tree/organic supports.
With supports
Layer height: 0.2
Brim: On
Cooling: 100% all the time
Avoid crossing curled overhangs: ON.
Support: Organic
Overhang threshold: ~35%
Support on built plate only
I recommend you use "paint on supports" and put a few supports inside both shells midway up to add some stability while it prints the second half. If you paint on a tiny dot on the inside, it should not leave anything visible from the outside. Do this 3-4 places around each shell halfway up the bauble. I have added a screenshot of the supports I have used.
Without supports
Layer height: 0.2 (Do not go lower as the pressure from the extruder will likely bend the thin elements too much)
Brim: On
Cooling: 100% all the time
Temperature: Absolute minimum of recommended range of your filament. Potentially 5-10 degrees lower.
Bed temperature: Turn it down to ~45 degrees after first layers. Chamber temperature as low as possible.
Avoid crossing curled overhangs: ON.
Disclaimer: I managed to get surface quality a lot better with a lot of experimentation, but the parts fan on my Core One sucks at cooling the overhangs on the "front" of objects. So even the best prints clearly has a good and bad side. For best results, support was definitely the best solution.
Assembly
Gently break of supports if used. It can be a little tricky to get them out from the middle, but carefully breaking them apart with needle-nose pliers or a small screwdriver helps.
Cut/saw off the bottom foot just where it meets the straight cylinder part.
Put on the cap and press the hanger in. It should stay in on its own, unless tugged on. If you have pets or small children in the house, consider a few drops of glue to secure the hanger.