1 / 11
Stealthburner Cable Cover with 2525 FAN for FYSETC SB COMBO v2 — image 1
1 / 11

Stealthburner Cable Cover with 2525 FAN for FYSETC SB COMBO v2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Original cover was interfering with the board, so i made one that doesn't. And add a 25mm FAN just for a case

Rating
0 / 5
Likes
11
Downloads
20
Makes
1
Views
241
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is ongoing project. I will update it as it progress thru possible iterations and extra parts i'll build for this toolhead.

FYSETC SB COMBO v2  is an USB/CAN toolboard for stealthburner toolhead. Original stealthburner cable cover were interfering with the board, so i had to open it for edit.

Changes performed to original model:
  • 2525 FAN slot added to the top to blow on both sides of PCB, also 

  • rear side shaped to outline PCB to guide air stream along hot surfaces (+interference fixed)

  • vent slots added to the side bottom, so air can escape after cooling chips

  • FAN cable retaining post added. It will save cable from bending/folding

  • M3 thread is added to the hole. Prints fine with 0.4 nozzle and 0.2layer. It is tight, but it helps to tap your own thread with screw.

  • added labels for: reset, boot buttons, and toolboard brandname

Model is more or less optimized for FDM with 0.4 nozzle.
You only have to add supports to hold fan slot wall, which is hanging flat horizontal.

In progress to add to this project:
  • 2525 fan grill/shroud

  • COMBO v2's original cable holder 

  • anything i will need to make new toolhead work properly

  • add lighter STL without thread?

  • add version with original rear wall outline?

Tags