Stealthburner Cable Cover with 2525 FAN for FYSETC SB COMBO v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Original cover was interfering with the board, so i made one that doesn't. And add a 25mm FAN just for a case
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 20
- Wydruki
- 1
- Wyświetlenia
- 235
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is ongoing project. I will update it as it progress thru possible iterations and extra parts i'll build for this toolhead.
FYSETC SB COMBO v2 is an USB/CAN toolboard for stealthburner toolhead. Original stealthburner cable cover were interfering with the board, so i had to open it for edit.
Changes performed to original model:
2525 FAN slot added to the top to blow on both sides of PCB, also
rear side shaped to outline PCB to guide air stream along hot surfaces (+interference fixed)
vent slots added to the side bottom, so air can escape after cooling chips
FAN cable retaining post added. It will save cable from bending/folding
M3 thread is added to the hole. Prints fine with 0.4 nozzle and 0.2layer. It is tight, but it helps to tap your own thread with screw.
added labels for: reset, boot buttons, and toolboard brandname
Model is more or less optimized for FDM with 0.4 nozzle.
You only have to add supports to hold fan slot wall, which is hanging flat horizontal.
In progress to add to this project:
2525 fan grill/shroud
COMBO v2's original cable holder
anything i will need to make new toolhead work properly
add lighter STL without thread?
add version with original rear wall outline?
