1 / 4
HeroMe Gen 7 modified for use on Sovol SV08 with BTT-eddy probe — image 1
1 / 4

HeroMe Gen 7 modified for use on Sovol SV08 with BTT-eddy probe

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

In the interests of saving time, I set this up to leave the hotend and BTT Eddy probe mounted to the stock backplate

Rating
0 / 5
Likes
5
Downloads
9
Makes
0
Views
284
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I have switched the airflow redirection to be done by a modified skirt insert which attaches to the bottom of the base. The stock HeroMe base should now work, but the one here (base.stl) has better airflow. I have tried printing the base in a few orientatioons, upright with supports for the bits that obviously need it is best. I have also added a left and right 4010 fan duct, which allows you to use the HeroMe withouth modifying the usable print are from stock.

I have updated the base adapters to center the HeroMe on the print nozzle. For some reason  Sovol put the nozzle 0.8mm off from the center of the toolhead, which does make a difference, especally for clearance of the skirt.

For reasons of simplifying assembly, I put M3 5mm diameter brass inserts directly into the bolt holes in the blower fans I am using, it makes everything very much easier...

The base adapter clips seem to work best printed with the chamfer along the spine flat against the plate and the arms going up at a 45 degree angle. 

The Board Adaptor STL file allows you mount the toolhead control board a bit offset from it's stock position to give clearance from the HeroMe base. This also includes two posts to mount a USB hub board I am using to control the BTT Eddy. Everything uses M3 4.2mm diameter brass inserts, except the USB posts, which takes an M2 3.2mm diameter insert. The USB hub board I used was an Adafruit LLC 5997, which I got from DigiKey.

This particular design is very specific to the BTT eddy mount I have, which is still attached to the backplate. The mount I am using is 

It is designed for round 4mm diameter by 3mm thickness magnets. I would have to modifythe design to work with the stock (or any other) probe. 

Tags